Advanced

Re: Request checker for GC8ABNQ – “Challenge – 1x81 + 2x81 + 3x81”

Dear all,
I would be interested to receive a challenge checker to check to following requirements:
1. You need at least one completed loop (of the 81 matrix) of only one particular cache type.
2. You need at least two completed loops of another cache type (different from point 1).
3. You need at least three completed loops of a third cache type (different from points 1 and 2).
Example: as aspired owner we have 1 competed loop of the matrix only with multi caches, 2 completed loops with Tradis and 3 completed loops with Mysterys.
For this challenge all cache types should be allowed, as long as the corresponding matrix is filled with the indicated number of loops.

Would it be possible to program such a checker or – alternatively – does anybody know an already existing checker for this challenge?

Best regards,
Paradiesnest
Re: Request checker for GC8ABNQ – “Challenge – 1x81 + 2x81 + 3x81”
July 05, 2019 10:27PM
Re: Request checker for GC8ABNQ – “Challenge – 1x81 + 2x81 + 3x81”
July 06, 2019 10:02AM
Many thanks for the quick response!
Re: Request checker for GC8ABNQ – “Challenge – 1x81 + 2x81 + 3x81”
July 06, 2019 10:05AM
I just made some minor changes (to make it generic), so you may want to test it once or twice again to make sure I didn't break anything.
Re: Request checker for GC8ABNQ – “Challenge – 1x81 + 2x81 + 3x81”
July 07, 2019 11:47AM
I have checked several potential candidates.

In cases where 2 loops and 3 loops are fine, but 1 loop is missing, there seems to be a bug. For example, for users "_Gobber_" and "Diddi *". In these cases you will see a green hook in the picture above, but the list at the bottom shows that 1 loop is not filled properly!
Re: Request checker for GC8ABNQ – “Challenge – 1x81 + 2x81 + 3x81”
July 07, 2019 12:08PM
Updated.

The requirement was set to 0 on the last run, now the requirement will never go below 1.
Re: Request checker for GC8ABNQ – “Challenge – 1x81 + 2x81 + 3x81”
July 07, 2019 05:28PM
Everything is fine.
Many thanks again!
Sorry, only registered users may post in this forum.

Click here to login